ایده آل کات



Once we have right dimensions it's time to virtually cut it.
هنگامی که ما را به ابعاد مناسب آن زمان ، عملا آن را قطع.
It's the hardest part because standard diamond shapes aren't just made of a series of standard lines.
آن را در سخت ترین بخشی به دلیل اشکال الماس استاندارد هستند از یک سری از خطوط استاندارد نه تنها ساخته شده است.
To make it correct just follow the screenshots and instructions below.
تا آن را درست فقط دنبال تصاویر و دستورالعمل های زیر کلیک کنید.
  • First make sure you are using Cut Tool.
    اول مطمئن شوید که شما با استفاده از ابزار برش.
    This will allow you to create some more edges on top of the diamond.
    با این کار به شما اجازه ایجاد بعضی از لبه های بیشتر در بالای الماس.
  • Then go to a Top viewport
    سپس به یک viewport صفحه بروید
  • We have to start with the center part and create there two squares
    ما باید با بخشی از مرکز شروع و ایجاد وجود دارد دو مربعات
  • The next step is to connect some vertices with the gridle.
    مرحله بعدی برای اتصال برخی از رئوس را با gridle.
    Make sure you are starting with the farthest vertex that is a part of one of the squares!
    اطمینان حاصل کنید که شما با شروع از دورترین راس آن است که بخشی از یکی از مربعات!
  • Select all the polygons around that are making specific shape presented on the fourth image and hit delete to get rid of them
    انتخاب همه polygons اطراف که ساخت شکل خاص ارائه شده بر روی تصویر چهارم و آمار حذف به خلاص از آنها
  • Use cap to fill the holes
    استفاده از کلاه را پر از سوراخ
  • Lastly select all the vertices you've previously connected with the gridle and move them down in Front viewport.
    بالاخره در راس همه شما قبلا با gridle وصل شده و انتقال آنها را در پایین viewport جبهه را انتخاب کنید.
    The value of this offset is hard to calculate but it's around 1.2 Max's units I guess
    مقدار این انحراف است که سخت است ، اما محاسبه آن را در اطراف واحد 1.2 حداکثر 'sمن حدس's
  • There are also some missing edges at the bottom of the diamond so you can simply use Cut Tool to create them.
    هم وجود دارد برخی از لبه های گم شده در انتهای این الماس پس شما می توانید به سادگی استفاده از ابزار برش به آنها ایجاد کنید.
wol errorClick this bar to view the small image.81